Page 10 - Spec book of North Cabinetry
P. 10

FIELD REPAIR OR MODIFICATION

         Many times, defects or errors can be corrected on the job site. In these situations, the dealer must receive
         advance authorization from North Cabinetry. North Cabinetry reserves the right to approve a field repair or
         decide arrangements for the return of the merchandise to the factory for rework.

         North Cabinetry may ask that item, considered defective, be returned to the factory before it is replaced. If it is
         in North Cabinetry's and the dealer's mutual best interest to leave a defective item on the job site until the remake
         is delivered, the defective part must be returned to the factory within 30 days. Credit for defective items will be
         issued upon their return to the factory with detailed references to original order (copy of original or shipping
         memo).




         DOOR WARPAGE


         Our experience has shown that some cabinet doors will warp slightly after installation in a new construction site
         because of high moisture. In older remodeled homes, warpage may occur because of low humidity.

         In order to avoid this situation, North Cabinetry controls the moisture content in the wood, but be aware that
         storage of cabinets in areas that are not temperature and humidity controlled will void the North Cabinetry
         warranty.

         Before replacing a door for warpage, please make sure that the door is warped rather than the cabinet being
         racked. Most warped doors may be adjusted by the door hinges. It is often a better solution to install some type
         of catch to flatten the door against the cabinet front, especially in the case of doors taller than 36", angled, mitered
         or radius doors. There is no warranty against warpage for doors taller than 42". In most situations, the door will
         return to its normal flat position after going through four seasonal changes.

         North Cabinetry will replace at no charge any doors that show more than ⅜" of warpage when placed on a flat
         surface.



         CARE & CLEANING

         CABINET BOX
            ▪   Immediately after installation, wipe up all residual dust and spills.
            ▪   If necessary, use mild soap and water. Do not forget to rinse and dry.
            ▪   Do not allow grease to built up.
            ▪   You must avoid use of abrasive type cleaners or pads.
            ▪   If above mentioned conditions are prevalent, North Cabinetry reserves the right to void the warranty.


         DOORS AND EXPOSED ENDS
            ▪   Clean  your  doors  &  exposed  ends  with  a  soft  damp  cloth  or  sponge  &  mild  soap  and  water  mix
                immediately after installation.
            ▪   You must avoid use of abrasive type cleaners or pads.
            ▪   For minor nicks and scratches that occur during installation, North Cabinetry provides touch up kits.
            ▪   Do not expose cabinets either to direct sunlight or extreme changes of temperature & humidity.
            ▪   If above mentioned conditions are prevalent, North Cabinetry reserves the right to void the warranty.
   5   6   7   8   9   10   11   12   13   14   15